Milling


Milling with evatec-tools

A productive solution: the wide range of tools brought to you by evatec-tools.

  • fraisage

Milling cutters with inserts:

  • fraise a plaquette

  • surfacing (types FS, FSH, FSG, FSR)
  • routing-copying (types DC, DCH)
  • copying (type CO)
  • bevelling (type FC)
  • groove cutting ( type RC)
  • counterboring (type FL)
  • reaming pin holes (type FRG)
  • thread cutting (type FI)
  • modular screw-in (types MCH - MRH - MBH: M10, M12, M14, M16)
  • elongated (types DCR - RCR - BHR: long or short)
  • SPECIAL (made to your requirements)


Milling cutters and reamers - braed carbide

  • fraise et alésoirs

helicoidal (2-tooth: 25°, 35° and light alloy; 3-tooth: 25°, 45°; TiN, TiCN coated; hemispherical)

  • shaped (conical 50° to 55°, 60°, T-slot)
  • 3 sizes (boring)
  • Reamers (1/30 hollow conical, smooth cylindrical shank, Morse taper)
  • SPECIAL brazed carbide tools (made to your requirements)


Integrated cutters for pattern making

  • hemispherical (short: Ø2 to Ø20; long: Ø6 to Ø20; reinforced: Ø2 to Ø20)
  • roughing and finishing (4- and 6-tooth, 50° helix; short: Ø3 to Ø20; long: Ø3 to Ø20)
  • toroidal (50° helix; Ø6 to Ø20)
  • hemispherical (Ø0.4 to Ø3)


Single insert ball nose end mills, ball nose inserts rate

Finish milling intends to moulds manufacturers, automotive moulds, glasswork moulds and in the machining of matrices to carry out specific forms, pocket matrices, in steel, super alloys or cast-iron moulds.

Copying single insert ball nose end mills : Single insert;

Copying single insert ball nose end mills : smooth cylindrical shank - Weldon;

Copying single insert ball nose end mills : extension cylindrical shank;

Copying single insert ball nose end mills : Morse cones;

Copying single insert ball nose end mills : To screw;

Copying single insert ball nose end mills : PRD insert reference.

 

 


Milling cutters for interpolative threading

  • fraise a filter

  • integrated carbide:
    • ISO 60°/ISO fine pitch
    • UN 60°/UNF
    • BSW 55°
    • BSP 55°
    • BSPT 55°
    • NPT 55°
    • NPTF 60°
    • PG 80°
    • T2 ISO and UN standard and fine
    • T3 ISO and UN standard and fine
    • Ø 35, 45 and 55 ISO and UN
  • indexable carbide inserts
    • carbide ISO and UN
    • BSP 55°
    • NPSM 60°
    • NPSF 60°
    • BSPT 55°
    • NPT 60°
    • NPTF 60°
    • cylindrical shank insert
    • reaming insert


Top of page

 

12 rue des terres rouges
ZI Metzange - 57100 Thionville
Tel : + 33 (0) 3 82 88 61 61
Fax : + 33 (0) 3 82 88 33 19